RESEARCH PAPER
Analysis of vertical vibrations affecting a child transported in a child seat during a car passing over the release speed bump
1
Wydział Mechatroniki i Budowy Maszyn, Politechnika Świętokrzyska w Kielcach, Polska
2
Wydział Mechatroniki i Budowy Maszyn, Politechnika Świętokrzyska, Polska
3
The Center for Smart City Networks,, The Center for Smart City Networks,
Sydney, Australia
Submission date: 2019-11-19
Final revision date: 2019-12-17
Acceptance date: 2019-12-18
Publication date: 2019-12-23
Corresponding author
Damian Paweł Frej
Wydział Mechatroniki i Budowy Maszyn, Politechnika Świętokrzyska w Kielcach, Aleja Tysiąclecia Państwa Polskiego, 25-340, Kielce, Polska
Wydział Mechatroniki i Budowy Maszyn, Politechnika Świętokrzyska w Kielcach, Aleja Tysiąclecia Państwa Polskiego, 25-340, Kielce, Polska
The Archives of Automotive Engineering – Archiwum Motoryzacji 2019;86(4):111-125
KEYWORDS
TOPICS
ABSTRACT
The article presents the results of research on the assessment of vibrational comfort of children carried in child seats. The work analyzes the impact of the child's mass and the speed of the car passing through the speed bump on the level of vibration to which the passenger (child) transported in the child seat mounted on the rear seat of the car is exposed. The tested car seats were installed in a passenger car using the ISOfix base. During the tests, the measured values were the acceleration of the seat child seat, the backrest of the child seat, the rear seat of the car and the child seat ISOfix base. As part of the research, car drive through the speed bump were carried out at different car speeds and with different mass simulating the mass of a child. The test results were analyzed in order to determine the magnitude of vibrations generated during car drive through the speed bump. Based on the results obtained, the level of vibrational comfort of a child trip in a child seat was assessed.
REFERENCES (23)
1.
Baranowski P., Damaziak K., Malachowski J., Mazurkiewicz L., Muszynski A.: A child seat numerical model validation in the static and dynamic work conditions. Archives Of Civil And Mechanical Engineering. 2015, 15(2), 361-375, DOI: 10.1016/j.acme.2014.07.001.
2.
Belwadi A., Sarfare S., Tushak S., Maheshwari J., Menon S.: Responses of the scaled pediatric human body model in the rear- and forward-facing child seats in simulated frontal motor vehicle crashes, Traffic Injury Prevention. 2019, 14, 1-2, DOI: 10.1080/15389588.2019.1661684.
3.
Gajek A.: Directions for development of periodic technical inspection for motor vehicles safety systems. The Archives of Automotive Engineering – Archiwum Motoryzacji. 2018, 80(2), 37-51, DOI: 0.14669/AM.VOL80.ART3.
4.
Giacomin J.: Some observations regarding the vibrational environment in child safety seats. Applied Ergonomics. 2000, 31(2), 207-215, DOI: 10.1016/S0003-6870(99)00034-4.
5.
Gong WD., Griffin MJ.: Measuring, evaluating and assessing the transmission of vibration through the seats of railway vehicles. Proceedings Of The Institution Of Mechanical Engineers Part F-Journal Of Rail And Rapid Transit. 2018, 232(2), 384-395, DOI: 10.1177/0954409716671547.
6.
Jurecki R., Stańczyk T.L.: Driver model for the analysis of pre-accident situations. Vehicle System Dynamics, 2009, 47(5), 589-612, DOI: 10.1080/00423110802276028.
7.
Kardas-Cinal E.: Methods of vibrational comfort evaluation in means of transport. Prace Naukowe Politechniki Warszawskiej. Transport. 2016, 112, 165-174.
8.
Krauze P., Kasprzyk J., Rzepecki J.: Experimental attenuation and evaluation of whole body vibration for an off-road vehicle with magnetorheological dampers. Journal Of Low Frequency Noise Vibration And Active Control. 2019, 38(2), 852-870, DOI: 10.1177/1461348418782166.
9.
Langwieder K., Hummel T., Roselt T.: ISOFIX - possibilities and problems of a new concept for child restraint systems. International Journal Of Crashworthiness. 2003, 8(5), 443-454, DOI:10.1533/ijcr.2003.0250.
10.
Lee S.K., White P.R.: Application of wavelet analysis to the impact harshness of a vehicle. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science. 2000, 214(11), 1331-1338, DOI: 10.1243/0954406001523308.
11.
Lesire P., Johannsen H., Willinger R., Longton A.: CASPER - Improvement of child safety in cars. Procedia Social and Behavioral Sciences. 2012, 48, 2654-2663, DOI: 10.1016/j.sbspro.2012.06.1235.
12.
Lozia Z.: Zastosowanie liniowego modelu „ćwiartki samochodu” do optymalizacji tłumienia w pasywnym zawieszeniu samochodu – wykorzystanie prac wielu autorów z okresu ostatnich 40 lat. The Archives of Automotive Engineering – Archiwum Motoryzacji. 2016, 71(1), 7-20, DOI:10.14669/AM.VOL71.ART3.
13.
Ma XG., Griffin R., McGwin G., Allison D.B., Heymsfield S.B., He W., et al.: Effectiveness of Booster Seats Compared With No Restraint or Seat Belt Alone for Crash Injury Prevention. Academic Emergency Medicine. 2013, 20(9), 880-887, DOI: 10.1111/acem.12204.
14.
Mazurkiewicz L., Baranowski P., Karimi HR., Damaziak K., Malachowski J., Muszynski A., et al.: Improved child-resistant system for better side impact protection. International Journal Of Advanced Manufacturing Technology. 2018, 97(9-12), 3925-3935, DOI: 10.1007/s00170-018-2236-y.
15.
Niu L., Gao Y.M., Tian Y. Pan S.M.: Safety awareness and use of child safety seats among parents after the legislation in Shanghai. Chinese Journal Of Traumatology. 2019, 22(2), 85-87, DOI: 10.1016/j.cjtee.2018.08.005.
16.
Ślaski G, Gudra A, Borowicz A.: Analiza wpływu zwiększenia masy nieresorowanej poprzez zabudowę silników elektrycznych w piastach kół na komfort i bezpieczeństwo jazdy samochodu osobowego. The Archives of Automotive Engineering – Archiwum Motoryzacji. 2014, 65(3), 51-64.
17.
Terelak P. Jurecki R.: Legal aspects of childrens transport in vehicles. Logistyka, Instytut Logistyki i Magazynowania. 2015, 4, 6190-6196.
18.
Vermote L.,Macharis C., Hollevoet J., Putman K.: Participatory evaluation of regional light rail scenarios: A Flemish case on sustainable mobility and land-use. Environmental Science & Policy. 2014, 37, 101-120, DOI: 10.1016/j.envsci.2013.08.013.
19.
Wieckowski D.: Frequency analysis of vertical vibrations acting on a baby transported in a child car seat. Journal of KONES. 2013, 20(1), 359-366.
20.
Wicher, J. Więckowski, D.: Influence of vibrations of the child seat on the comfort of child's ride in a car. Polskie Naukowo-Techniczne Towarzystwo Eksploatacyjne, Eksploatacja i Niezawodność. 2010, 48(4), 102-110.
21.
Więckowski D., Jaśkiewicz, M.: The impact of the safety belt used for chairs used in buses and minibuses with small-speed collisions. Zeszyty Naukowe Akademia Morska w Szczecinie. 2014, 39(111), 74-81.
22.
Zhao H., Guo L., Zeng X.: Evaluation of Bus Vibration Comfort Based on Passenger Crowdsourcing Mode. Mathematical Problems in Engineering. 2016, 10, 1-10, DOI: 10.1155/2016/2132454.
23.
Zuska A., Więckowski D., Frej D,: A Comparative Study of Vehicle Absorbers. 11th International Science and Technical Conference Automotive Safety, AUTOMOTIVE SAFETY. 2018, 1-6, DOI: 10.1109/AUTOSAFE.2018.8373350.
CITATIONS (16):
1.
Simulation investigation of individual bumps recognition posibilities for damping control and possible suspension performance improvements
Zbyszko Klockiewicz, Grzegorz Slaski, Krzysztof Dabrowski
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
Zbyszko Klockiewicz, Grzegorz Slaski, Krzysztof Dabrowski
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
2.
Analysis of the impact of a child seat mounting method on vertical vibrations affecting a child in a child seat
Andrzej Zuska, Emilia Szumska, Damian Frej
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
Andrzej Zuska, Emilia Szumska, Damian Frej
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
3.
Test Stand for Experimental Crash Tests at Low Speeds
Damian Frej, Marek Jaśkiewicz
Transportation Research Procedia
Damian Frej, Marek Jaśkiewicz
Transportation Research Procedia
4.
Selection of child seats in terms of vibration comfort
D Frej, A Zuska, P Kubiak
IOP Conference Series: Materials Science and Engineering
D Frej, A Zuska, P Kubiak
IOP Conference Series: Materials Science and Engineering
5.
Road safety perspective of small children
Marian Gogola, Jan Ondrus
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
Marian Gogola, Jan Ondrus
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
6.
Overview of design solutions for child seats
Damian Frej, Krzysztof Podosek, Kelvin To
The Archives of Automotive Engineering – Archiwum Motoryzacji
Damian Frej, Krzysztof Podosek, Kelvin To
The Archives of Automotive Engineering – Archiwum Motoryzacji
7.
Application of CAN bus data in road tests of automobiles
Krzysztof Rokicki, Mateusz Brukalski, Hubert Sar
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
Krzysztof Rokicki, Mateusz Brukalski, Hubert Sar
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
8.
Laboratory Tests of the Control of the Child Seats using Method for the Vibration Comfort of Children Transported in Them
Andrzej Zuska, Emilia Szumska, Damian Frej
Communications - Scientific letters of the University of Zilina
Andrzej Zuska, Emilia Szumska, Damian Frej
Communications - Scientific letters of the University of Zilina
9.
Analysis of the Causes of Vehicle Accidents in Poland in 2009-2019
Emilia Szumska, Damian Frej, Paweł Grabski
LOGI – Scientific Journal on Transport and Logistics
Emilia Szumska, Damian Frej, Paweł Grabski
LOGI – Scientific Journal on Transport and Logistics
10.
Laboratory studies of the influence of the working position of the passenger vehicle air suspension on the vibration comfort of children transported in the child restraint system
Damian Frej, Andrzej Zuska, Emilia Szumska
Open Engineering
Damian Frej, Andrzej Zuska, Emilia Szumska
Open Engineering
11.
Analysing the Vibration of Bicycles on Various Road Surfaces in the City of Zilina
Marián Gogola
The Archives of Automotive Engineering – Archiwum Motoryzacji
Marián Gogola
The Archives of Automotive Engineering – Archiwum Motoryzacji
12.
Shoulder joint design of the anthropometric dummy used for crash tests
Marek Jaskiewicz, Dariusz Wieckowski, Milos Poliak, Damian Frej
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
Marek Jaskiewicz, Dariusz Wieckowski, Milos Poliak, Damian Frej
2020 XII International Science-Technical Conference AUTOMOTIVE SAFETY
13.
Vibration Comfort Evaluation of Child Safety Seat Based on Vehicle Ride Comfort
Hao Donghui, Zhang Jie, Qiang Yi, An Jianying, Zhang Jin
2023 IEEE 3rd International Conference on Electronic Technology, Communication and Information (ICETCI)
Hao Donghui, Zhang Jie, Qiang Yi, An Jianying, Zhang Jin
2023 IEEE 3rd International Conference on Electronic Technology, Communication and Information (ICETCI)
14.
Analysis of the selection of a child seat
Łukasz Karwala
The Archives of Automotive Engineering – Archiwum Motoryzacji
Łukasz Karwala
The Archives of Automotive Engineering – Archiwum Motoryzacji
15.
Impact of Consumer Value on the Selection of a Safe Child Seat
Damian Frej, Paweł Grabski
Communications - Scientific letters of the University of Zilina
Damian Frej, Paweł Grabski
Communications - Scientific letters of the University of Zilina
16.
Upper Limb Design of an Anthropometric Crash Test Dummy for Low Impact Rates
Marek Jaśkiewicz, Damian Frej, Dariusz Tarnapowicz, Milos Poliak
Polymers
Marek Jaśkiewicz, Damian Frej, Dariusz Tarnapowicz, Milos Poliak
Polymers
Share
RELATED ARTICLE
Korzystamy z plików cookie (oraz innych podobnych technologii) i przetwarzamy unikalne identyfikatory oraz dane przeglądarki – w celu umożliwienia funkcjonowania naszej strony internetowej. Więcej informacji o tym jak przetwarzamy Twoje dane osobowe znajdziesz w
